Sensha_Michi
New member
Ok, so I might have made a mistake when ordering a set of arrows from Merlin, I shoot a compound that was bought with a set of arrows and was advised that the fletches go "two facing down" toward the launcher to allow clearance.
Now my new Easton XX75's arrived t'other week and the fletches were in what i like to call the "Recurve Position" to allow riser clearance.
They are Easton pin nocks (a metal insert in the end of the shaft with a plastic nock fitted to that, is there a way of rotating the nock so my fletches are aligned?
I am off to Quicks tomorrow so if its difficult or technical I will ask them to do it, thanks in advance for any advice you give
Now my new Easton XX75's arrived t'other week and the fletches were in what i like to call the "Recurve Position" to allow riser clearance.
They are Easton pin nocks (a metal insert in the end of the shaft with a plastic nock fitted to that, is there a way of rotating the nock so my fletches are aligned?
I am off to Quicks tomorrow so if its difficult or technical I will ask them to do it, thanks in advance for any advice you give