Fuse Fuse Clinch - adjustment?

10point9

New member
Hi all,

I just bought a Fuse Clinch Dual Caliper - it says that it has "full sensitivity adjustment on the trigger", but there are no instructions on how you do this. Also, other than adjusting the wrist strap, is there a way of adjusting the length of the barrel? It says 'adjustable reach for perfect fit', but again, as there are no instructions, I'm at a loss as to how this is done...

Anyone know?
 

geoffretired

Supporter
Supporter
Looking at the pictures, I would guess adjusting the barrel, is done by tightening the nut on the end of the bolt that fits into the strap at the plastic mount. The bolt is covered by a rubber tube, which squashes shorter as you tighten the nut onto the bolt.
For sensitivity, usually there is a small Allen screw down inside a hole, near the trigger.( just below quite often)
Screwing that inwards, usually makes it more sensitive, go in too far and the release won't close.
 
Top