Fuzzy
Member
I have a completely standard Cartel RX10 bowstand which has been blown over three times this year because of the wind despite being properly set up with the ground spike and everything. That's three times too many. I want to make some slot on feet to spread the weight out from the end of the legs. These will replace the rubber caps. Think duck feet.
I've got measurements for my stand but could I ask people to grab their stands and measure the diameter of the legs ( without caps)? The more data points I have the more models I can make this fit.
If you have bar-type feet like on the RX101 then I can probably make that fit as well if you've got the measurements. I'll upload the file somewhere so you can 3d print it once I've got the dimensions worked out.
I've got measurements for my stand but could I ask people to grab their stands and measure the diameter of the legs ( without caps)? The more data points I have the more models I can make this fit.
If you have bar-type feet like on the RX101 then I can probably make that fit as well if you've got the measurements. I'll upload the file somewhere so you can 3d print it once I've got the dimensions worked out.