Stiks
Member
Hi all,
Back here after a good while out of archery.
I'm wanting to refinish my Blackbrook Zeta C. I've searched for Andy's site but it appears he's closed shop, I hope it was not illness?
My income is really low these days so doubt I could afford a refinish by him anyway but his advice would've been welcome.
As you no doubt know it has a carbon fibre back, it's not bare carbon, obviously has a finish of some type over it, epoxy, lacquer or ?
I was thinking of using a good spar varnish like TotalBoat Clear 2, it's easy to apply dries quickly and builds up nicely, friendly to use.
I'm not inexperienced with a brush but by no means an expert. I'd appreciate some advice / guidance re-coating this great bow?
Then it's practice, practice and practice some more before joining the NFAS again.
Back here after a good while out of archery.
I'm wanting to refinish my Blackbrook Zeta C. I've searched for Andy's site but it appears he's closed shop, I hope it was not illness?
My income is really low these days so doubt I could afford a refinish by him anyway but his advice would've been welcome.
As you no doubt know it has a carbon fibre back, it's not bare carbon, obviously has a finish of some type over it, epoxy, lacquer or ?
I was thinking of using a good spar varnish like TotalBoat Clear 2, it's easy to apply dries quickly and builds up nicely, friendly to use.
I'm not inexperienced with a brush but by no means an expert. I'd appreciate some advice / guidance re-coating this great bow?
Then it's practice, practice and practice some more before joining the NFAS again.