Recurve Limb bolts

wolfblood

New member
Hi

I have got a lovely piece of laminated hardwoods comprised of about 8 contrasting layers.

About 30 inches long by 3 inches by 6 inches that was going to be used as an art base but is not needed now.

I got the idea it would make a lovely low power recurve riser but cannot find anywhere to get the limb bolt assemblies I would need.

Any ideas?

Regards

Dean
 


roytherecurve

New member
If you have access to the the materials and machinery, You may have to make your own limb pockets, ferrules and bolts as I dont think any of the major manufacturers would supply them as spares!
 


geoffretired

Supporter
Supporter
Dean, are you thinking of limb bolt assemblies as seen on beginners' risers or the complex versions seen on top end bows?
 


simon182

New member
or maybe buy a cheepy takedown bow off the old ebay, and strip the bits from that bow? then sell on the limbs, string etc?
 


Dennarcher

New member
Hi,

Maybe you club has some really old tatty beginners (sorry I dont mean tatty old beginners)take downs? Perhaps you could by one for a small contribution to the club kitty?

Dennis.
 


Top