I am seeing witness marks on the shelf of my riser where a vane is hitting it - marks pretty much full length on the shelf. This appears to be pretty much every arrow and I am assuming it isn't just bad form (although I could be proved wrong!).
At the moment I am just getting used to the bow so not ready for proper tuning yet but it would be nice to understand the cause for when I get to that point.
So, what is likely to be causing it? From reading around I get the impression nock point too low or perhaps a low brace height? Is this right?
for info, the bow is basically untuned (just very basic setup at the shop), brace height is just over 22cm (70" bow, according to the manual that is at the bottom of the range) and nock point is about 3mm above horizontal). Rest is a hoyt superest, no pressure button yet.
At the moment I am just getting used to the bow so not ready for proper tuning yet but it would be nice to understand the cause for when I get to that point.
So, what is likely to be causing it? From reading around I get the impression nock point too low or perhaps a low brace height? Is this right?
for info, the bow is basically untuned (just very basic setup at the shop), brace height is just over 22cm (70" bow, according to the manual that is at the bottom of the range) and nock point is about 3mm above horizontal). Rest is a hoyt superest, no pressure button yet.