ok. I made my first set of wooden arrows ( to go with a pvc bow i made)
i used super glue ( probably the mistake) on the points. shot them into my layered foam target, and the tips started to come off.
Took them off, re- glued and heated the tips.
gave them a while to harden / dry, and gave a couple a tug with pliars to check they were on well.
fired them into target, and they came off
( I now have 4 arrow points inside my layered foam, that i can get out)
so.. any body got any helping advice, I just ordered some insert iron from merlin...
and what woudl you suggest about the tips in the foam layers, is it ok to leave them or do i really have to take the whole thing apart to get them out ( its only a month or so old, so not even slightly shot out yet)
i used super glue ( probably the mistake) on the points. shot them into my layered foam target, and the tips started to come off.
Took them off, re- glued and heated the tips.
gave them a while to harden / dry, and gave a couple a tug with pliars to check they were on well.
fired them into target, and they came off
( I now have 4 arrow points inside my layered foam, that i can get out)
so.. any body got any helping advice, I just ordered some insert iron from merlin...
and what woudl you suggest about the tips in the foam layers, is it ok to leave them or do i really have to take the whole thing apart to get them out ( its only a month or so old, so not even slightly shot out yet)